BMI Acrylic 500 FINE

Fine Finish

BMI Acrylic 500 Fine Finish is a ready mixed, flexible textured wall coating used as a decorative and protective wall finish over prepared vertical, above grade concrete, masonry and plaster/stucco substrates. BMI Acrylic 500 Fine Finish produces an “ornamental trowel” texture or “spray” texture for sculpted decorative effects such as lace or “skip-trowel”.

Where to use

BMI Acrylic 500 Fine Finish may be used over prepared: 

  • Stucco base coats
  • Exterior gypsum board lids
  • Concrete masonry in exterior/interior applications
  • Drywall 
  • Cement board
  • Sealed gypsum plaster

Advantages

  • Excellent adhesion and UV resistance
  • Dirt pick up resistance 
  • Available in standard and custom colors

PREPARATION:

Mixing:
Mix with a drill mixer and jiffler paddle or similar paddle. Do not exceed 400 r.p.m. when mixing or the product could be air entrained which will increase "pin holing" and decrease bonding characteristics Up to 8 ounces of clean potable water may be added to BMI Acrylic 500 until desired consistency is achieved.

Application:
BMI Acrylic 500 Fine Finish should be applied with a stainless steel trowel. Enough material should be applied to cover all surfaces. Always apply BMI Acrylic 500 in continuous application, working to a wet edge to avoid cold joints. Finish material with a plastic float using a "figure 8" pattern. Avoid water drops and runs on uncured material. 

Coverage:

65 lb. pail BMI Acrylic 400 115-125 sq/ft
(coverage will vary depending on texture, substrate and suction).

Specifications:

Color:
Available in all 30 of our stock colors from our BMI Exterior Color Guide, or custom colors available upon request. 

Shelf Life:
Twelve months when stored in a cool dry location (50° - 90°F Keep out of direct sunlight and protect from freezing).

Curing/Drying:
BMI Acrylic 500 will dry to touch in 1-4 hours and will be fully cured in 21 days. Low temperatures, high humidity, driving rains etc. can prolong cure time.