BMI Acrylic Primer 100

Acrylic Primer

BMI Acrylic Primer 100 is a premium acrylic protective exterior primer. Primer 100 can be used to protect most exterior surfaces including stucco, stem and foundation wall.

BMI Primer 100 is designed to be used over high pH cementitious surfaces such as stucco, tilt-up concrete, prepared masonry and brick.

Where to use

BMI Acrylic Primer 100 is designed to be used over: 

  • High pH cementitious surfaces such as stucco 
  • Tilt-up concrete
  • Prepared masonry and brick

Advantages

BMI Acrylic Primer 100 can be used to protect most exterior surfaces including stucco, stem and foundation wall. 

PREPARATION:

Mixing:
Mix with a drill mixer for 1 minute, or until consistent, prior to use. Do not exceed 400 rpm. when mixing or the product could be air entrained which will decrease bonding characteristics. Up to 16 ounces of clean potable water may be added to BMI Primer 100 to aid in spray application.

Application:
BMI Primer 100 exterior acrylic paint may be applied with brush, roller or approved spray equipment. If rolling apply evenly not allowing roller marks. Apply finish coat after prime coat has fully dried. If spraying material, spray in a side to side or up and down pattern. Always apply BMI Primer 100 in continuous application, working to a wet edge to avoid cold joints. Avoid water drops and runs on uncured material.

Coverage:

52 lb. pail BMI Primer 100 = 500-750 sq. ft. per pail @ 4 mils. Dry thickness
(coverage will vary depending on texture, substrate and suction).

Specifications:

Color:
White (custom colors are available upon request).

Shelf Life:
Twelve months when stored in a cool dry location 50° - 90°F. Keep out of direct sunlight and protect from freezing. 

Curing/Drying:
BMI Primer 100 average drying time averages 3 hours depending on ambient temperature, humidity and film thickness. BMI Primer 100 will dry completely within 12 hours.