Sikadur Crack Weld

Crack injection kit

Two component, low viscosity, fast curing epoxy sealing system for repairs to cracks in concrete and solid masonry. Conforms to ASTM C-881.

Where to use

  • Low pressure injection of cracks in structural concrete and solid masonry.
  • Gravity feed cracks in horizontal concrete and horizontal solid masonry.

Advantages

  • As strong as concrete.
  • Convenient mix in the nozzle cartridge system. 
  • Cartridges fit standard caulking guns.

Preparation:

mixing

Cartridge Set Up: 

  • Sikadur Capseal - Open screw cap, cut film to remove metal clip and attach nozzle, extrude waste until a uniform color is achieved. 
  • Sikadur Injection Resin - Remove screw cap, insert outlet plugs, attach mixer nozzle with extension tube*. 
  • Extrude waste to form a homogeneous mix. Use the push fit connector to connect to injection port.

*For horizontal cracks (floor, slab, etc.), remove the extension tube.

Application

For Vertical Cracks (walls, columns, beams) - The resin should be injected into the first (lower) port. When the resin begins to flow from the adjacent port, close off the first port and disconnect the hose. Reconnect to the second port and inject until resin starts to flow from the third; this process is repeated until the whole crack has been injected. After the resin has been allowed to cure, the injection ports and capseal should be removed and any holes or voids should be filled. For Horizontal cracks (floors, slabs, etc.) - To gravity feed cracks, seal the underside of the substrate prior to filling if the crack reflects through. Dispense the injection resin slowly into the vee-notched crack. Continue injecting until completely filled.

Coverage:

10.1 fl. oz. cartridge seals 12.4 lineal ft. of 1/2 x 1/4 in. joint. 20 fl. oz. uni-pac sausage seals 24 lineal ft. of 1/2 x 1/4 in. joint.