SikaQuick VOH

Fast Setting, one component, cementitious vertical and overhead repair mortar with superior high build properties

SikaQuick® VOH is a fast setting, one component, ready-to-use repair mortar for vertical and overhead applications using specialty cement blends.

where to use

  • Fast repairs to overhead and vertical concrete and mortar surfaces on grade, above and below grade.
  • As a repair material for building facades, parking structures, industrial plants, bridges, etc.
  • As a fast setting repair material for new construction defects.


  • Minimal time required between lifts.
  • Fast finishing time
  • Time/labor-saving material; application up to 3 inches on vertical surfaces in one layer
  • Easy to use; just add water
  • High bond strength ensures excellent adhesion
  • High early and ultimate strength
  • Increased freeze/thaw durability and resistance to deicing salts
  • Suitable for exterior and interior applications.
  • Not a vapor barrier
  • Overhead thickness up to 2"
  • Fiber reinforced and polymer modified
  • Contains corrosion inhibitor



Wet down all tools and mixer to be used. Mix mechanically with a low-speed drill (400 - 600 rpm) and mixing paddle or mortar mixer. Mix to a uniform consistency, maximum 3 minutes. Manual mixing can be tolerated only for less than a full unit. Thorough mixing and proper proportioning of the powder and liquid is necessary. Inaccurate proportioning of the powder to liquid will result in a finished product that may not conform with stated properties.

With water: Start mixing with 6 pints of water per 44 lb. bag. Adjust the water dosage by a maximum amount of +/- 1/2 pint, if necessary, to achieve the desired consistency. Do not over-water. Over-watering may result in difficulty handling and/or not meeting stated property values.

With Latex R: Start mixing with 6 pints of SikaLatex ® R per 44 lb. bag. Adjust the SikaLatex ® R dosage by a maximum amount of +/- 1/2 pint, if necessary, to achieve the desired consistency 


The mixed SikaQuick® VOH must be worked well into the prepared substrate, filling all pores and voids. Compact well. Force material against edge of repair working towards the center. Thoroughly compact the mortar around exposed reinforcement. After filling repair, consolidate, then screed. Finish with steel, magnesium, wood, plastic floats, or damp sponges, depending on the desired surface texture. Where multiple lifts are required, score top surface on each lift to produce a roughened substrate for next lift. Allow preceding lift to harden before applying fresh material. Saturate surface of the lift with clean water. If previous layers are over 6 hours old, mechanically prepare the substrate and dampen.


~.44 cu. ft.