Show all documents

BMI Mesh

Glass fiber reinforcing mesh

BMI Mesh is a specialty woven, alkali resistant glass fiber reinforcing mesh used with BMI 777 Polymer-Modified Base Coat to provide impact resistance and strength.

  • Meets ASTM D-3775, ASTM D-3776, ASTM D-1777, ASTM D-5035
BMI Mesh
Show all documents

Usage

  • BMI Mesh is primarily used with BMI 777 Polymer-Modified Base Coat in accordance with EIFS specifications.
 
  • It can also be used to integrate EPS shapes and over stucco in restoration projects to help resist cracking.
  • Recommended for all applications and low traffic areas, second floor and higher as well as specialty shapes, parapets, irregular detail work inside and outside corners.

Advantages

  • Meets ASTM D-3775, ASTM D-3776, ASTM D-1777, ASTM D-5035

Packaging

Field Mesh

48” wide x

150 linear feet

4 rolls per box
Detail Mesh

91/2” wide x

450 linear feet

16 rolls per box

Color

Off-white

Product Details

Product Information

Shelf Life

24 months from date of production

Storage Conditions

Store dry and protect from moisture

Application

Consumption

Coverage

4.5 oz/yd

 
Application steps

SUBSTRATE PREPARATION

  • Before applying EPS insulation board, attach BMI Mesh from the edges of all planned termination points of the insulation with base coat.
  • This strip of mesh will wrap the edge of the insulation when the base coat is applied “back wrapping”.
  • The EPS insulation must be well fastened or adhered to the substrate.
  • If insulation board has been adhesively applied, wait at least 24 hours before continuing work on the surface.
  • Fill 1/8” (3.2 mm) gaps and larger in insulation board with slivers of EPS.
  • Cut slivers flush with razor blade and rasp entire surface of insulation board.
  • EPS insulation board shall not vary more than 1/8” (3.2 mm) in every 8’ (2.4 m) span.
  • Cut any aesthetic joints at this time.
  • Brush or blow off all insulation dust from wall.
  • To complete the back wrapping of the insulation board, apply the base coat to the underside and approximately 6” (15.2 cm) up the insulation board.
  • Starting from the underside, trowel in the BMI Mesh fully into the base coat.
  • Do not leave any wrinkles in the mesh.
  • Feather the base coat onto the insulation board.

Documents