5 gallon pail.
4 - 6
2 years in original unopened container under proper storage conditions.
Store dry between 40° - 90°F (5°- 32°C).
35 + 1%
7.8 - 8.0 lbs.
110 - 115°F
20 - 50 cps
Not recommended for or marketed as a topcoat.
Allow the sealer to dry 6 - 24 hours before recoating. Seal with a second coat of Sikafloor WP-11.1. Adequate ventilation is imperative during the curing process. Dry times will vary bases upon the drying conditions. Do not apply when temperature is above 95°F or below 65 F, or when relative humidity is above 80%. Clean up with mineral spirits.
300-500 square feet per gallon
Lightly blend product prior to application. Do not introduce air bubbles. THIS PRODUCT IS DESIGNED TO BE USED AS IS. DO NOT THIN OR REDUCE WITH SOLVENTS.
Apply line marking paint after the second seal coat. Follow the directions on the paint label for application. Abrade the paint lines lightly with #120 grit screens following cure and prior to finishing.
Tooling & Finishing
With a conventional lambswool or foam applicator or weighted T - bar, apply Sikafloor WP-11.1 going with the grain. Do not puddle sealer. Allow the sealer to dry 6 - 24 hours before recoating. Seal with a second coat of Sikafloor WP-11.1.
In case of spill, eliminate all ignition and heat sources. Ventilate area. Open doors and windows. Wear chemical resistant gloves/goggles/clothing. In absence of proper ventilation use properly fitted NIOSH respirator. Use explosion proof equipment and spark proof tools. Confine spill, collect using noncombustible absorbent material and place in properly sealed container. Dispose of excess product in accordance with applicable local, state and federal regulations.