Sikafloor® WP-8

MFMA TESTS:

2 years in original unopened container under proper storage conditions.

Store dry between 40° - 90°F (5°- 32°C).

<450 g/L

Flash Point:

(60°) 90+

Allow over night cure (16 hrs min. 36 hrs max.) before recoating. Finish with a second coat of WP-8. Allow 48 hours cure before light traffic and 5 - 7 days before athletic activities. Adequate ventilation is imperative during the curing process. Dry times will vary based upon the drying conditions. Do not apply when temperature is above 95° F (35°C) or below 65° F (18°C), or when humidity is above 80%. Clean up with mineral spirits.

400-500 sq. ft/ gal. (37 m2-46.5m2/L)

THIS PRODUCT IS DESIGNED TO BE USED AS IS DO NOT THIN OR REDUCE WITH SOLVENTS.

With a conventional lambswool or foam applicator or weighted T - bar, apply Sikafloor WP-8. Do not puddle finish.

In case of spill, eliminate all ignition and heat sources. Keep away from heat, sparks, sunlight, electrical equipment or flame. VAPORS MAY IGNITE AND EXPLODE. DO NOT SMOKE. Ventilate area. Open doors and windows. Wear chemical resistant gloves/goggles/clothing. In absence of proper ventilation use properly fitted NIOSH respirator. Confine spill, collect using noncombustible absorbent material and place in properly sealed container. Dispose of excess product in accordance with applicable local, state and federal regulations.