SikaQuick®-800

• Meets ASTM C 928, Type R3

12 months from date of manufacture if stored properly in original, unopened and undamaged, sealed packaging

Store dry at 40° - 95° F (4° - 35° C)

Protect from moisture. If damp, discard material.

6 - 6.5 pints (2.8 - 3.1 L )

• Do not feather edge

     *  Minimum thickness is 1/2" (12.7 mm) with the use of SikaQuick® Winter Boost

65° - 75° F (7° C)

> 45° F (7° C)

20° - 45° F ( -7° - 7° C) with the use of SikaQuick^® Winter Boost

> 45° F (7° C)

20° - 45° F (-7° - 7° C) on a frost-free surface with the use of SikaQuick^®  Winter Boost

Approximately 15 minutes

Product temperature will affect the Application Time:

• Above 73° F (23° C) will reduce the Application Time and workability
• Below 73° F (23° C) will extend the Application Time and workability

0.43 ft³ (0.012 m³)
(Yield figures do not include allowance for surface profile, porosity or material waste)

• Wet down all tools and mixer to be used.
• Pour 6 pints (2.8 L) of clean potable water [approximately 70° F (23° C)] into a suitably sized and clean mixing container, using a calibrated measuring jug or similar, to ensure strict control of the water content.
• Add 1 pail while continuing to mix with a low-speed drill (400-600 rpm) and mortar mixing paddle or in an appropriate mortar mixer.
• Once all the powder has been added, mix to a uniform consistency, maximum 3 minutes, until a lump-free blend is achieved.
• Add up to an additional 1/2 pint (0.24 L) maximum of liquid to achieve desired consistency. Do not over-water.
• Thorough mixing and proper proportioning of the powder and liquid is necessary.
• Inaccurate proportioning of the powder to liquid will result in a finished product that may not conform to the typical published performance property values.

• A neat mix of SikaQuick®-800 mortar must be scrubbed into the mechanically prepared, SSD substrate. Be sure to work into all pores and voids.
• Force material against edge of repair, working toward center. After filling repair area, screed off excess.
• Allow material to set to desired stiffness, then finish with wood or sponge float for a smooth finish, or broom or burlap-drag for a rough finish.
• If a smoother finish is desired, a magnesium float should be used.
• Mixing, placing, and finishing should not exceed 15 minutes maximum.
• Refer to ACI 305 the "Guide to Hot Weather Concreting" or ACI 306 the "Guide to Cold Weather Concreting" when there is a need to place this product while either hot or cold temperatures prevail. Thinner placements will be more sensitive to the temperature conditions.

• As per ACI recommendations for Portland cement concrete, curing is required.
• Moist cure with wet burlap and polyethylene, a fine mist of water or Sika® Antisol®-250W*.
• Curing compounds adversely affect the adhesion of following lifts of mortar, leveling mortar or protective coatings.
• Moist curing should commence immediately after finishing. Protect freshly applied mortar from direct sunlight, wind, rain, and frost.

*pretest of curing compound is recommended