SikaEmaco® P 130

2 years when properly stored

Store and transport in unopened containers in a cool, clean, dry area. Keep from freezing.

100%

800 mixed, cps, at 77° F (25° C)

Component ‘A’: Component ‘B’ = 2:1 by volume.

Test results are averages obtained under laboratory conditions. Expect reasonable variations.
All application and performance values are typical for the material, but may vary with test methods, conditions,
and configurations. Unless otherwise noted, test samples were cured 7 days at 73° F (23° C) and 50 % relative humidity

150–200 ft² per gal(3.7–7.4 m²/L), depending on substrate texture and porosity

• The minimum air, substrate, and material application temperature is 50° F (10° C). Lower temperatures will significantly slow curing time.
• Do not apply if the temperature exceeds 90° F (32° C). Large quantities of mixed material and high ambient temperatures will reduce pot life significantly.
• For professional use only; not for sale to or use by the general public.
• Make certain the most current versions of the product data sheet and SDS are being used.
• Proper application is the responsibility of the user. Field visits by Sika personnel are for the purpose of making technical recommendations only and are not for supervising or providing quality control on the jobsite.

1. Concrete substrates must be fully cured (28 days), clean, and sound; they can be dry or damp but with no standing water.
2. Remove all grease, oil, chemical contamination, dust, laitance, and loose concrete by mechanical profiling to ICRI CSP 4 to provide a sound substrate.
3. Complete all necessary repairs prior to application and allow the surface to reach loadbearing strength.

1. Precondition all components to 70° F (21° C) for 24 hours before using.
2. If the entire kit of SikaEmaco® P 130 will not be used, smaller quantities can be mixed in the ratio of 2:1 (A:B) Mix ratios are critical; measure carefully.
3. Premix each of the components thoroughly, until homogeneous, using a Jiffy paddle attached to a low-speed (400–600 rpm) heavy-duty drill.
4. In a separate mixing vessel add Part A, then Part B. Stir until uniform in color without streaks, approximately 3 minutes. Scrape the sides of the containers, removing as much material as possible to ensure correct mixing ratios.

1. Brush, squeegee, or roll the mixed SikaEmaco® P 130 onto the prepared concrete surface. Take care to avoid puddling in depressions.
2. If the primer is absorbed within 30 minutes, apply a second coat. If the primer becomes contaminated, it must be sanded and reapplied.
3. Apply MBT protective coatings after the primer is tack-free––approximately 3–4 hours. Maximum recoat time is 48 hours.

• Clean equipment immediately after use with xylene.
• Clean hands and skin immediately with soap and water, industrial hand cleaner, or denatured alcohol.
• Cured material must be removed mechanically.