Sikagard®-62

2 years in original, unopened containers.

Store dry at 40°-95°F (4°-35°C). Condition material to 65°-75°F (18°-24°C) before using.

Mixed: Approximately 3,500 cps.

Abrasion (Taber Abrader)

Weight loss, 1,000 cycles (H-22 wheel, 1,000 gm weight)

Adhesion Classification

Water Absorption

(24 hour immersion)

Component ‘A’ : Component ‘B’=1:1 by volume.

Approximately 35 to 40 minutes. (60 gram mass).

Tack-Free Time:  Approximately 4 hours.

Open Time: Light foot traffic: 5-7 hours. Rubber-wheel traffic: 8-10 hours.

Immersion and Chemical Exposure: Minimum cure: 3 days

Approximately 150-250 ft.2/gal. depending on condition of substrate.

Surface must be clean and sound. It may be dry or damp, but free of standing water. Remove dust, laitance, grease, curing compounds, impregnations, waxes and any other contaminants.
Preparation Work: Concrete - Should be cleaned and prepared to achieve a laitance and contaminant free, open textured surface by blast cleaning or equivalent mechanical means.
Steel - Should be cleaned and prepared thoroughly by blast cleaning.

Pre-mix each component. Proportion equal parts by volume of Components ‘A’ and ‘B’ into a clean mixing container. Mix with a low-speed (400-600 rpm) drill using a Sika paddle for 3 minutes, until uniform in color.

Apply coating using high-quality roller, brush or spray. Two coats are recommended. Apply second coat as soon as the first coat is tack-free and the traffic of application will not damage the first coat. The second coat, however, must be applied within 48 hours since a longer delay will require additional surface preparation. Do not spray with slip resistant granules mixed into the coating. For use as a seamless flooring system, consult Technical Service.