SikaFix® HH+

1 year in original unopened container

Store in a dry area between 40–90 °F (4–32 °C) using original re-sealable containers

<1%

Absorption < 1%                  (ASTM D2842)

180 °F (82 °C) max

Based on 2.5 % SikaFix Accelerator dosage, corresponding with the recommended 5 gallon:1 pint ratio of SikaFix HH+ to SikaFix Accelerator. SikaFix Accelerator must be agitated by shaking the container prior to use.

When the crack is contaminated on the outside, it will be necessary to clean the crack surface so that the crack can be exactly located. If the crack is wide or high water flows are encountered, it will be necessary to seal the surface of the crack with a surface sealing material (SikaSet Plug or open cell polyurethane foam saturated with SikaFix® HH+). The surface sealing can be done before or after drilling the injection holes, depending on the particular situation.

Prior to installation, the material should be agitated by vigorously shaking the 5-gallon pail or by mixing with a jiffy mixer, bung mixer or by hand. Prior to using SikaFix Accelerator, the container should be shaken vigorously as the contents may settle during storage. For normal use, each 5 gallon unit of SikaFix® HH+ should be used with one pint container of SikaFix Accelerator, a dosage of 2.5 %. The grout should never be used with more than 5 % SikaFix Accelerator. Excess acceleration will cause vigorous expansion that is prone to shrinkage. Pour the desired amount of SikaFix HH+ into a clean pail. Measure the appropriate amount of SikaFix Accelerator and pour it into the SikaFix® HH+ and mix adequately.