Sikalastic® TC 299 FS

• CSA S413
• ASTM C957

2 years

Store in unopened containers in a cool, clean, dry area. Materials should be protected from heat, direct sunlight, moisture and impact.

Taber Abrasion Resistance

Sikalastic® 918 FS is the catalyst for Sikalastic® TC 299 FS at all temperatures. Chart details amount of Sikalastic® 918 FS recquired, based on temperature, added to one (1) gallon of Sikalastic® TC 299 FS resin. 

Note: Values Sikalastic® 918 FS (fl. oz.)

* For temperatures not listed on this dosing chart, please contact your Sika representative. 

7-15 min, based on temperature.

1 hour

80 ft²/gal. at 20 mils 

60 ft²/gal. at 25 mils

NOTE:  Coverage rates provided are optimal and are not guaranteed - coverage rates will vary depending on temperature, surface roughness and porosity, aggregate selection and embedment, and application technique.

Sikalastic® TC 299 FS is a multiple-component that utilizes a methyl-methacrylate (MMA) resin. It is critical that the instructions listed in the Safety Data Sheet and on the product label for every component of the system be read, understood, and followed. MMA resins are flammable liquids in their uncured state. Smoking, open flames, or sparks should not be permitted during the handling of the product. Explosion-safe ventilation must be used during the application to minimize vapor collection in the installation area and to improve overall air quality for the crew. All foodstuffs must be removed during installation of the system.

Color

• Sikalastic® TC 299 FS pigmented: Mix 6 oz of Sikafloor® PGM 155 pigment for every one (1) gallon of resin
• Sikalastic® TC 299 FS CLEAR does not require any powder pigment.

Mixing

• Sikalastic® TC 299 FS pigmented measure 1 gallon of resin and 6 oz of pigment into a 5-gallon pail. Mix for 2-3 minutes.
• Add the proper amount of powder hardener and mix for an additional 1-2 minutes. See the mixing ratio chart above.
• Note: After mixing, apply immediately. You will have 7 – 15 minutes of working time, dependent on temperature.

See Mixing Ratio section for the required amount of Sikalastic®-918 FS (in volume ounces) for one-gallon resin, based on temperature at the time of application.

Apply at the recommended coverage rate (see appropriate System Product Data Sheet) using a notched or flat squeegee, and backroll using a phenolic resin core roller. Allow coating to cure a minimum of 1 hour between coats or opening to traffic. 

Clean tools with Sikafloor®-100 CLN Pronto, an MMA solvent. Other solvents such as xylene or acetone may also be used. Collect and dispose of all site waste.