SikaTile®-100 Moisture Guard

FAST DRYING ELASTOMERIC WATERPROOFING AND CRACK ISOLATION MEMBRANE

SikaTile®-100 Moisture Guard is a single component, fast-drying, thin mil, load-bearing waterproofing, and crack isolation membrane for installation under ceramic tile or stone in residential, commercial, and industrial environments. With excellent elongation, adhesion, and high strength properties, SikaTile®-100 Moisture Guard provides a thin, continuous barrier to protect adjacent rooms and floors below from water damage. For common change of plane areas such as coves, corners, cracks, and drains, it can be combined with optional Reinforcing Fabric to provide additional protection. SikaTile®-100 Moisture Guard dries in 2 to 4 hours depending on ambient conditions and is then ready to receive any Sika polymer or epoxy mortar. SikaTile®-100 Moisture Guard is IAPMO-listed for use as a shower-pan liner, can be flood-tested after 4 to 6 hours of drying time, and exceeds ANSI A118.10 and ANSI A118.12 standards.

  • For use in areas that require positive waterproofing
  • Crack Isolation up to 1/8” 
  • Fast drying, foot traffic in 2 – 4 hours
  • Flood test after 4 – 6 hour cure
  • Excellent elongation will inhibit the transfer of cracks
  • Antimicrobial for mold and mildew resistance at the substrate
  • Easy installation with brush, roller, or trowel
  • Excellent adhesion – bonds to most flooring surfaces
  • Does not increase surface elevation
  • Interior or exterior
  • Low VOC’s
 
SikaTile®-100 Moisture Guard