Sikalastic®-715 LoVOC Textured

12 months in original, unopened containers

Store dry at 40–95 °F (4–35 °C).

Condition material to 65–85 °F (18–30 °C) before using.

Resistant to deicing salts, and alkaline concrete and cementitious mortars/tile adhesives

70 sf/gal at 16 wet mils (14 dry mils)
60 sf/gal at 18 wet mils (16 dry mils)
53 sf/gal at 20 wet mils (18 dry mils)

Coverage rates provided are intended to achieve required wet film thickness under optimal conditions. Additional material may be required depending on substrate surface roughness and porosity, material, substrate and air  temperatures, and other site-dependent factors. This will result in a lower coverage rate.

Thoroughly mix Sikalastic®-715 LoVOC Textured for 3 minutes using a mechanical mixer (Jiffy) at slow speed until a homogenous mixture and uniform color is obtained . Make sure to scrape the solids and the aggregate from the bottom and sides of the pail. The aggregate should be evenly diffused in the resin. Use care not to allow the entrapment of air into the mixture.

Wear coat: Apply at the recommended coverage rate 18 mils wet (60 sf/gal) using a 1/8” or 3/16” notched squeegee or trowel, and backroll using nap roller 3/8” to uniformly backroll prior to applying topcoat. It should be backrolled two times, one perpendicular to the other.

Top coat: Apply at the recommended coverage rate 18 mils wet (60 sf/gal) using a 1/8” or 3/16” notched squeegee or trowel, and backroll using nap roller 3/8” to uniformly backroll. The Top coat should be backrolled two times, one perpendicular to the other. Allow coating to cure a minimum of 4 hours at 70 °F and 50 % R.H.; coating must be tack free before overcoating. Allow coating to cure for a minimum of 36 hours before opening to vehicular traffic

Booster - Sikalastic® 715 Top Lo-VOC Booster may be added to Sikalastic®-715 LoVOC Textured in order to speed cure time. Mix thoroughly prior to application. Add a maximum of 1 quart to 4.75 gallons (or 1:19 ratio) and only to material that will be applied within 1 hour. Allow coating with booster to cure a minimum of 6 hours at 70 °F and 50 % R.H. or until tack fee between coats. Allow coating to cure for a minimum of 36 hours before opening to vehicular traffic or installing separate wear course.

Removal

Remove liquid coating immediately with dry cloth. Once cured, coating can only be removed by mechanical means.