Sikalastic®-391

12 months in original, unopened containers

Store dry at 41–95 °F (5–35 °C).

Condition material to 65–85 °F (18–30 °C) before using.

Resistant to deicing salts.

35–40 minutes

100 ft²/gal at 16 wet mils (16 dry mils)
  89 ft²/gal at 18 wet mils (18 dry mils)
  64 ft²/gal at 25 wet mils (25 dry mils)

Coverage rates provided are intended to achieve required wet film thickness under optimal conditions. Additional material may be required depending on substrate surface roughness and porosity, material and substrate temperatures, and other site-dependent factors. This will result in a lower coverage

Premix Part A and Part B components using a low speed (400–600 rpm) mechanical mixer and Jiffy Paddle at slow speed to obtain uniform color, making sure to scrape the solids from the bottom and sides of the pail. Pour part B into Part A slowly and while mixing scrape the side of the container, Mix the combined material thoroughly until a homogenous mixture and uniform color is obtained (typically 3 minutes). Use care not to allow the entrapment of air into the mixture.

Apply at the recommended coverage rate (see appropriate System Guide) using a 3/16” notched squeegee or trowel, and back roll using a phenolic resin core roller. Apply aggregate evenly distributed at the appropriate rate immediately into wet coating and back roll if required (see appropriate System Guide). Allow coating to cure a minimum of 10 hours at 70 °F and 50 % R.H.; coating must be tack free between coats. Allow coating to cure for a minimum of 48 hours before opening to vehicular traffic.

Aggregate: Use clean, rounded or semi-angular oven dried quartz sand with a size gradation of 16–30 mesh for vehicular traffic and 20–40 mesh for pedestrian traffic, and a minimum hardness of 6.5 per the Moh’s scale. For high friction surfaces #3 flint aggregate can be used and evenly broadcasted to rejection . It should be supplied in pre-packaged bags and free of metallic or other impurities. Seeding of aggregate means an even, light broadcast short of refusal. Back roll aggregate where indicated. A full broadcast of aggregate means a heavy application to refusal. Any loose aggregate must be removed prior to re coating. 

Removal

Remove liquid coating immediately with dry cloth. Once cured, coating can only be removed by mechanical means.