Product Data Sheet Safety Data Sheet Show all documents
DriTac® 8410 EnviroTread®

DriTac® 8410 EnviroTread®

Rubber Underlayment for Glue Down and Floating Hardwood, Carpet & Carpet Tile, Ceramic Tile & Stone, and Laminate FlooringSOUND

DriTac 8410 EnviroTread is a high performance 5mm rubber underlayment and acoustical barrier for successful installations of hardwood, carpet & carpet tile, ceramic tile & stone, and laminate flooring. DriTac 8410 EnviroTread offers the Total Sound Reduction System (SRS) enhanced lifetime warranty when utilized in conjunction with approved Sika-DriTac flooring adhesives in ‘double-stick’ applications. EnviroTread is made from 100% post-consumer waste, affording the green community the best sound abatement choice for their sustainable projects.

• 4’ x 25’ = 100 sq. ft./roll
• Anti-Crush Mechanical Properties
• Improved Foot Fall Sound Performance
• Diminishes Minor Floor Irregularities
• Dual Force, Silent Fuse Technology with SRS
• For Residential and Commercial Applications
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Hardwood
  • Carpet
  • Carpet Tile
  • Ceramic Tile
  • Stone
  • Laminate
 

Advantages

• 4’ x 25’ = 100 sq. ft./roll
• Anti-Crush Mechanical Properties
• Improved Foot Fall Sound Performance
• Diminishes Minor Floor Irregularities
• Dual Force, Silent Fuse Technology with SRS
• For Residential and Commercial Applications

Packaging

Available in 100 sf individual product rolls

Product Details

Product Information

Shelf Life

N/A

Storage Conditions

Store rolled rubber underlayment on a clean, dry, smooth surface, and avoid storing it on its end.

Application

Application steps

APPLICATION INSTRUCTIONS

GLUE-DOWN INSTALLATION INSTRUCTIONS - 3-EASY STEPS - TROWEL APPLIED

1. Cut underlayment to length and lay loosely over the area to be installed. 2. Pull the loose laid material back at least half the length of the roll. Using the recommended trowel, apply approved adhesive to the subfloor. Allow approved adhesive to flash (no flash time needed for MS polymer or urethane adhesives) for recommended time prior to placing underlayment into adhesive. Upon placing underlayment into the adhesive, roll both ways with a 100 lb roller. Repeat the installation for the other half of the subfloor, insuring all joints are butted together tightly. 3. Allow adhesive to set prior to proceeding to flooring installation. See adhesive product label for additional flashtime information. It is highly recommended to allow at least 18 hours prior to installation of the flooring. Notes: Refer to flooring manufacturer and ANSI or TCNA handbook for ceramic tile and stone installations and thinset recommendations. Always check with the flooring manufacturer for installation recommendations. For glue down applications, please consult flooring adhesive recommendation for trowel and coverage.

 

FLOATING FLOOR INSTALLATION - 6 EASY STEPS

1. Check for nails 2. Sweep or damp mop 3. Roll out 1 width of membrane 4. Cut roll at the wall 5. Install flooring planks 6. Roll out next width. Repeat steps 3 to 6 until floor is completed. Never mechanically fasten the isolation barrier with screws, nails or staples as this will severely diminish the acoustical values of the barrier.

Documents