SikaGrout®-350

12 months from date of production if stored properly in original, sealed packaging

Store dry at 40–95 °F (4–35 °C)Protect from moisture. If damp, discard material

6.5 pts - 7.0 pts (3.1 L - 3.3 L)

*Only fluid consistency

65–75 °F (18–24 °C)

40° - 95° F (4° - 35° C)

> 40 °F (4 °C)

60 min. at 73 °F (23 °C) 50% R.H

0.4 ft3 (0.01 m3) per bag at fluid consistency(Coverage figures do not include allowance for surface profile and porosity or material waste)

• Make sure all forming, mixing, placing, and clean-up materials are on hand.
• Add the appropriate amount of water of clean potable water (approx. 70 °F) into a suitably sized and clean mixing container, using a calibrated measuring jug, or similar, to ensure strict control of the water content (do not over-water).
• Add 1 bag while continuing to mix with a low-speed drill (400-600 rpm) and Sika mixing paddle or a jiffy paddle or in an appropriate mortar mixer.
• Once all the powder has been added, mix for approximately 3 minutes, until a lump-free and uniform consistency is achieved. Do not over mix.
• For warmer temperatures use cold water and for colder temperatures use warm water
• Refer to ACI 306 Guidelines when there is a need toplace this grout in cold & hot temperatures.

• Within 15 minutes after mixing, place grout into forms in normal manner to avoid air entrapment
• Vibrate, pump, or ram grout as necessary to achieve flow or compaction
• Mixed grout in mass will result in faster than expected setting times
• SikaGrout®-350 must be confined leaving minimum exposed surface
• After grout has achieved final set, remove forms, and shape exposed grout shoulders to designed profile

Wet cure for a minimum of 3 days or apply Sika® Antisol-250 W which complies with ASTM C-309 on exposed surfaces.