Sikalastic®-710 Base

12 months in original, unopened containers

Store dry at 40–95 °F (4–35 °C).
Condition material to 65–85 °F (18–30 °C) before using.

6500 ± 3000 cps

See Product Safety Data Sheet

Resistant to deicing salts, and alkaline concrete and cementitious mortars/tile adhesives

50 sf/gal. at 32 wet mils (23 dry mils)

Coverage rates provided are intended to achieve required wet film thickness under optimal conditions. Additional material may be required depending on substrate surface roughness and porosity, material and substrate temperatures, and other site-dependent factors. This will result in a lower coverage rate.

Thoroughly mix coating using a mechanical mixer (Jiffy) at slow speed until a homogenous mixture and uniform color is obtained (typically 1 minute). Use care not to allow the entrapment of air into the mixture.

Apply at the recommended coverage rate (see appropriate System Guide) using a notched squeegee or trowel, and backroll using a phenolic resin core roller. Extend base coat over entire area including previously detailed cracks and joints. Allow coating to cure a minimum of 16 hours at 70 °F and 50 % R.H. or until tack fee before top coating.

When used under an overburden system an additonal coat of Sikalastic®-710 Base, fully broadcast, is required, allow coating to cure for a minimum of 72
hours before installing separate overburden such as tile.

Removal

Remove liquid coating immediately with dry cloth. Once cured, coating can only be removed by mechanical means.