Sikafloor® P 200

450 days when properly stored

Store in unopened containers in a clean, dry area. Keep from freezing.

Cure time is approximately 2–3 hours, depending on ambient temperatures and humidity. Allow Sikafloor® P 200 to dry 2–24 hours before applying a second coat of primer. The final coat of primer should dry to a tack-free condition before the placement of Sikafloor®-100 SL Pronto. Sikafloor®-100 SL Pronto must be applied within 12 hours after priming or the substrate will require another application of primer diluted 1 to 1 with water.

One gallon of Sikafloor® P 200 diluted with 1 gallon of water covers approximately 200–400 ft² (18.6–37.2 m²). Estimated coverage rate will vary based upon profile and porosity of the substrate.

Refer to the product data sheet for Sikafloor®-100 SL Pronto underlayment before beginning installation.

• Concrete surfaces must be fully cured, structurally sound, clean, and free of dust, oil, grease, water, curing compounds, sealers, waxes, paint, or any contaminants that might inhibit proper bond.
• Fill and grout all cracks and drilled or sawed holes to prevent seepage of Sikafloor® P 200 or Sikafloor®-100 SL Pronto.
• Designed joints in substrate must be carried through the application of Sikafloor®-100 SL Pronto.
• The surface to be repaired must be clean, strong, and prepared in accordance with ICRI Guideline No. 310.2 (CSP 3-5) to permit proper bond.

Stir for 1 to 2 minutes with a clean stir stick using the dilution ratios appropriate for the porosity of the substrate (see the Application section below).

1. Use Sikafloor® P 200 on dampened substrates only. Dampen the substrate before application, but do not oversaturate and leave puddles of water.
2. Apply Sikafloor® P 200 with a brush or roller, working the primer thoroughly into the substrate. Avoid leaving puddles of primer in low areas.

• Nonporous surfaces: use 1 coat of undiluted Sikafloor® P 200.
• Semi-porous surfaces (including steel troweled concrete): use 1 coat of Sikafloor® P 200 diluted 1 to 1 with clean water.
• Porous surfaces: may require 2 coats of Sikafloor® P 200. Dilute the first coat with 2 parts clean water to 1 part primer. Dilute the second coat with 1 part clean water to 1 part primer.

Immediately clean equipment with soap  and water.