LaHabra® Color Coat Tint Pack

NA

Unopened, undamaged, original sealed bag that is properly transported and stored. 

• 1 Tint pack per 90 lb. bag of Exterior Stucco Color Coat for standard color
• Up to 4 Tint Packs per 90 lb. bag of Exterior Stucco Color Coat for increased color depth

1. Using a mechanical plaster mixer, mix one (1)
   90 lb. bag of appropriate stucco tint base with
   approximately three (3) gallons of potable water
   to a thin consistency until it is smooth and free
   of lumps.
2. Add all of the color packs (1 per bag for a
   standard color, a maximum of 4 standard color
   packs can be added per 90 lb. bag for increased
   color depth) to be used for one “batch” and mix
   until color is evenly dispersed, (approximately 1
   to 2 minutes).
3. Thin the mixture with water and then add the
   remaining bags of stucco base (adjusting water
   as necessary) to correspond with the number of
   color packs mixed in step 2. Allow material to
   mix at a somewhat stiff consistency for
   approximately 15 minutes. Add the remaining
   amount of water to achieve the desired
   consistency, and then disengage the mixing
   blades for approximately 5 to 10 minutes in
   order to temper the material. Doing this allows
   the material to start its initial set. Re-engage the
   mixing blades for approximately 5 minutes,
   adjusting the water and mixing only long
   enough to achieve uniformity. The material is
   now ready to be removed from the mixer and
   applied to the wall. 
4. For additional batches of the same material,
   thin the remaining mixture with water, then
   repeat steps 3 & 4. Wash out mixer completely
   to change colors.