Product Data Sheet Safety Data Sheet Show all documents
Sika® Fleece-140 (US)

Sika® Fleece-140 (US)

Polyester fleece reinforcement for Sikalastic® RoofPro systems

Nonwoven, needle punched polyester fleece reinforcement used to enhance the strength and durability of Sikalastic® RoofPro roofing and waterproofing ssystems.

  • Permits wet on wet application of Sikalastic® 621 TC (US), Sikalastic®-624 WP, Sikalastic®-641 Lo VOC and Sikalastic®-644 Lo VOC
  • Creates strong reinforced roofing and waterproofing membranes with enhanced tensile strength
  • Fleece thickness dictates membrane thickness
  • Reduces pinholding due to outgassing
  • Increases puncture and tear resistance
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Ideal in roofing and waterproofing applications when detailing complex and geometricaly shaped surfaces or when accessibility is limited
  • Suitable for applications where visibility of reinforcement overlaps is an aesthetic concern
  • One-day system installation
 

Advantages

  • Permits wet on wet application of Sikalastic® 621 TC (US), Sikalastic®-624 WP, Sikalastic®-641 Lo VOC and Sikalastic®-644 Lo VOC
  • Creates strong reinforced roofing and waterproofing membranes with enhanced tensile strength
  • Fleece thickness dictates membrane thickness
  • Reduces pinholding due to outgassing
  • Increases puncture and tear resistance

Packaging

48'' w (1.2 m) x 300' (91.44 m), individually bagged rolls
16" w (0.41 m) x 300' (91.44 m), individually bagged rolls

Colour

White

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

  • FM Approved (as a system component of Sikalastic RoofPro)
Product Information

Shelf Life

N/A

Storage Conditions

Store flat and wrinkle-free in original, unopened and undamaged sealed packaging in dry conditions

Condition material to 50–77 °F (10–25 °C) before using for ease of application.

Area Density

140 g/m2

Application

Application steps

APPLICATION

Precut Sika® Fleece-140 (US) and dry-fit to horizontal field and vertical flashing conditions. Temporarily remove fleece. Apply approximately 2/3 of the specified resin quantity to primed substrate surface with a 1/2” (12.7 mm) nap phenolic resin core roller. Immediately fit and place Sika® Fleece-140 (US) into wet resin, overlapping reinforcement 3” (76.2 mm) along the sides and 6” (152.4 mm) at the roll ends. Apply wet roller to topside with light pressure to saturate from bottom and to ensure that air pockets are completely removed. Immediately apply the remaining 1/3 of the specified resin quantity and apply wet roller to topside with light pressure to fully saturate the membrane to achieve an even texture and appearance.
 

 

Documents