Product Data Sheet Show all documents
Sika® Fleece-170 (US)

Sika® Fleece-170 (US)

Polyester fleece reinforcement for Sikalastic® single component resin systems

Nonwoven, needle punched polyester fleece reinforcement to enhance the strength and durability of Sikalastic® single component resins used in roofing and waterproofing systems.

  • Permits wet on wet application of Sikalastic® 621 TC (US), Sikalastic®-624 WP, Sikalastic®-641 Lo VOC and Sikalastic®-644 Lo VOC
  • Creates strong reinforced roofing and waterproofing membranes with enhanced tensile strength
  • Fleece thickness dictates membrane thickness
  • Reduces pinholeing due to outgassing
  • Increases puncture and tear resistance
Product Data Sheet Show all documents

Usage

  • Ideal in roofing and waterproofing applications when detailing complex and geometrically shaped surfaces or when accessibility is limited
  • Suitable for applications where visibility of reinforcement overlaps is not an aesthetic concern
  • One-day system installation
 

Advantages

  • Permits wet on wet application of Sikalastic® 621 TC (US), Sikalastic®-624 WP, Sikalastic®-641 Lo VOC and Sikalastic®-644 Lo VOC
  • Creates strong reinforced roofing and waterproofing membranes with enhanced tensile strength
  • Fleece thickness dictates membrane thickness
  • Reduces pinholeing due to outgassing
  • Increases puncture and tear resistance

Packaging

48'' w (1.2 m) x 300' (91.44 m), individually bagged rolls

Color

White

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

  • FM Approved (as a component of Sikalastic systems)
Product Information

Shelf Life

N/A

Storage Conditions

Store flat and wrinkle-free in original, unopened and undamaged sealed packaging in dry conditions.

Recommended to condition material to 50–77 °F (10–25 °C) before using to match liquid resin.

Area Density

170 g/m2

Application

Application steps

APPLICATION INSTRUCTIONS

Precut Sika® Fleece-170 (US) and dry-fit to horizontal field and vertical flashing conditions. Temporarily remove fleece. Apply approximately 2/3 of the specified resin quantity to primed substrate surface with a 1/2” (12.7 mm) nap phenolic resin core roller. Immediately fit and place Sika® Fleece-170 (US) into wet resin, overlapping reinforcement 3” (76.2 mm) along the sides and 6” (152.4 mm) at the roll ends. Apply wet roller to topside with light pressure to saturate from bottom and to ensure that air pockets are completely removed. Immediately apply the remaining 1/3 of the specified resin quantity and apply wet roller to topside with light pressure to fully saturate the membrane to achieve an even texture and appearance.
 

Documents